Power Cord Routing
Warning: Make sure the power cord is unplugged before attempting to route it around or through the
treadmill.
Connect the power cord to the power receptacle in the front of the treadmill. The power cord can be run to the
user-front left or right sides depending on installation / site needs.
Note: To accommodate treadmill incline, at least 2 ft. (24”) of power cord is required between the outlet
and the last power cord clip for outlets in front of the treadmill.
Warning: Keep the area 6.5 ft. (2 m) by 3 ft. (0.9 m) behind the treadmill clear of any obstructions, including
walls, furniture, and other equipment. Contact Customer Support Services for an optional longer power cord
if necessary.
Danger: Ensure that the power cord does not contact the striding belt or get pinched between the frame,
lift arm or under the wheels; failure to follow this warning may result in serious injury.
Danger: Assurez-vous que le cordon d’alimentation n’entre pas en contact avec le tapis et ne soit pas pincé
entre le cadre, le bras de levage ou sous les roues. Le non respect de cet avertissement peut provoquer de
graves blessures.
DescriptionItem
Power Receptacle1
Frame2
Wheel3
Lift Arm4
Striding Belt5
Page 12 of 31
To Next Page
Loading...
Need help?
General
