CycleOps Joule 3.0 - Setting Up Display

Joule 3.0 User Guide page 60
Chapter 7: Setting Up CycleOps Joule 3.0 ™
Setting Up Display
Joule 3.0 display can be customized for viewing preferences. PowerAgent software may also be
used to change settings.
1. Press and release [MODE] until Menu mode is displayed.
2. Press [JOYSTICK] up/down to highlight Setup Joule. Press [JOYSTICK] in and release to select Setup Joule.
3. Press [JOYSTICK] up/down to highlight Display. Press [JOYSTICK] in and release to select Display.
4. Press [JOYSTICK] up/down to highlight Backlight Level. Press [JOYSTICK] in and release to select Backlight
Level.
5. Press [JOYSTICK] up/down to change Backlight Level from 1-10. Press [JOYSTICK] in and release to save
settings. Note: Backlight Level10 is the brightest level, 1 is the dimmest. Press [JOYSTICK] in and release to save
changes.
6. Press [JOYSTICK] up/down to highlight Backlight Timeout. Press [JOYSTICK] in and release to select Back-
light Timeout.
7. Press [JOYSTICK] up/down to change Backlight Timeout from Off, 2 seconds, 5 seconds, 30 seconds, 1 minute
or On. Note: the backlight will turn on after any button is pressed and remain on for the duration of the Back-
light Timeout setting. Press [JOYSTICK] in and release to save changes.
8. Press [JOYSTICK] up/down to highlight Contrast. Press [JOYSTICK] in and release to select Contrast.
9.Press [JOYSTICK] up/down to change Contrast from 1-10. Press [JOYSTICK] in and release to save settings.
Note: Contrast setting 1 offers little distinction between black and white shades while setting 10 offers greater
distinction between black and white shades. Press [JOYSTICK] in and release to save changes.
10. Press JOYSTICK up/down to highlight Power Smoothing. Press [JOYSTICK] in and release to select Power
Smoothing.
11. Press [JOYSTICK] up/down to change Power Smoothing from 1, 2,3,5,10,30. Press [JOYSTICK] in and release to
save settings. Note: Power smoothing 1 displays power data as it is sent from the power sensor, Power smooth-
ing 30 displays power data as a 30 second rolling average which can be used for better pacing during intervals
and races. Press [JOYSTICK] in and release to save changes.
12. Press [JOYSTICK] up/down to highlight Power With Zeros. Press [JOYSTICK] in and release to select Power
With Zeros.