EasyManuals Logo

CYG PRS-7910 User Manual

Default Icon
75 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
PRS-7910
52 PRS-7910
11 Installation
11.1 General
The equipment must be shipped, stored and installed with the greatest care.
Choose the place of installation such that the communication interface and the controls on the
front of the device are easily accessible.
Air must circulate freely around the equipment. Observe all the requirements regarding place of
installation and ambient conditions given in this instruction manual.
Take care that the external wiring is properly brought into the equipment and terminated correctly
and pay special attention to grounding. Strictly observe the corresponding guidelines contained in
this section.
11.2 Safety Instructions
Modules and units may only be replaced by correspondingly trained personnel. Always observe
the basic precautions to avoid damage due to electrostatic discharge when handling the
equipment.
In certain cases, the settings have to be configured according to the demands of the engineering
configuration after replacement. It is therefore assumed that the personnel who replace modules
and units are familiar with the use of the operator program on the service PC.
WARNING!
ONLY insert or withdraw a module while the device power supply is switched off. To this
end, disconnect the power supply cable that connects with the power supply module.
NOTICE!
Industry packs and ribbon cables may ONLY be replaced on a workbench for electronic
equipment. Electronic components are sensitive to electrostatic discharge when not in
the unit's housing.
NOTICE!
Jumper links may ONLY be changed on a workbench for electronic equipment.
Electronic components are sensitive to electrostatic discharge when not in the unit's
housing.
NOTICE!
A module can ONLY be inserted in the reserved slot. Components can be damaged or
destroyed by inserting module in a wrong slot.
The basic precautions to guard against electrostatic discharge are as follows:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CYG PRS-7910 and is the answer not in the manual?

CYG PRS-7910 Specifications

General IconGeneral
BrandCYG
ModelPRS-7910
CategoryNetwork Hardware
LanguageEnglish