PRS-7910
60 PRS-7910
13 Decommissioning and Disposal
13.1 Decommissioning
13.1.1 Switching off
To switch off this relay, switch off the external miniature circuit breaker of the power supply.
13.1.2 Disconnecting cables
Disconnect the cables in accordance with the rules and recommendations made by relational
department.
DANGER!
Before disconnecting the power supply cables that connected with the power supply
module of this relay, make sure that the external miniature circuit breaker of the power
supply is switched off.
DANGER!
Before disconnecting the cables that are used to connect analog input module with the
primary CT and VT, make sure that the circuit breaker for the primary CT and VT is
switched off.
13.1.3 Dismantling
The rack of this relay may now be removed from the system cubicle, after which the cubicles may
also be removed.
DANGER!
When the station is in operation, make sure that there is an adequate safety distance to
live parts, especially as dismantling is often performed by unskilled personnel.
13.2 Disposal
In every country there are companies specialized in the proper disposal of electronic waste.
NOTICE!
Strictly observe all local and national regulations when disposing of the device.
To Next Page
Loading...
Need help?
General