3 INSTALLATION
Things You Need
• Touch 7 Display
• Mounting bracket (supplied)
• 4 x self tapping mounting screws (supplied)
• DC Power connector (supplied)
• NMEA2000 drop cable (supplied) and t-connector
• 3A fuse
• Screw driver and drill bits
• Electrical Tools
Mounting Location
When selecting a location for your product it is important to consider the following factors:
• Ensure mounting compartment is of suitable size with adequate airflow
• Ensure display is mounted in a location where it will not be subjected to excessive vibration
• Ensure display is mounted in a location where the operator can easily use controls and clearly
see the screen
• Ensure display is mounted in a location that allows proper routing, support and connection of
cables
• Ensure there is sufficient clearance on each side of display to access release tabs for removal
• Ensure cables have adequate strain relief to prevent stress on connectors
• Select a location that is far enough away from devices that may cause interference, such as
motors, generators and radio transmitters/receivers.
• The display has a high-contrast screen, and is viewable in sunlight, but for best results install
the unit out of direct sunlight.
Warning! Inadequate ventilation may cause the unit to overheat. The unit is designed to
operate in temperatures from -20° C to +70° C (-4° F to +158° F)
To Next Page
Loading...