D-Link AC1900 - Page 64

60D-Link DIR-878 User Manual
Section 4 - Conguration
If Smart Connect is Disabled the following options are available:
2.4GHz / 5GHz
Status: Enable or disable the 2.4 GHz / 5 GHz wireless network.
Wi-Fi Name (SSID): Create a name for your wireless network using up to 32 characters.
Password: Create a password to use for wireless security.
Advanced Settings
Security Mode: Choose None or 81"81"1FSTPOBMrecommended).
802.11 Mode
(2.4 GHz):
Select the desired wireless networking standards to use.
The available options for the 2.4 GHz wireless network are .JYFE
CHO, .JYFEHO, 802.11n only.
802.11 Mode
(5 GHz):
Select the desired wireless networking standards to use.
The available options for the 5 GHz wireless network are .JYFE
BOBD, .JYFEOBD, BDPOMZ.JYFEBO,
.JYFEOPOMZ, or 802.11a only.
Wi-Fi Channel: Select the desired channel. The default is "VUP (recommended).
Transmission
Power:
Select the desired wireless transmission power.
Channel Width
(2.4 GHz):
Select "VUP if you are using both 802.11n and non-802.11n
devices, or select .)[ if you are not using any 802.11n devices.
Channel Width
(5 GHz):
Select "VUP if you are using 802.11ac, 802.11n, and 802.11a
devices, select "VUP if you are using 802.11n and 802.11a
devices, or select .)[ if you are only using 802.11a devices.
Wireless - Smart Connect Disabled