D-Link AC1900 - Ipv4;Ipv6 Rules

68D-Link DIR-878 User Manual
Section 4 - Conguration
IPv4/IPv6 Rules
The IPv4/IPv6 Rules section is an advanced option that lets you congure what
kind of trac is allowed to pass through the network. To congure the IPv4
rules, from the Firewall Settings page click IPv4 Rules. To congure IPv6 rules,
from the Firewall Settings page click IPv6 Rules. To return to the main Firewall
Settings page, click "EWBODFE.
To begin, use the drop-down menu to select whether you want to "--08 or
%&/: the rules you create. You can also choose to turn ltering 0''.
If you wish to remove a rule, click on its trash can icon in the Delete column. If
you wish to edit a rule, click on its pencil icon in the Edit column. If you wish to
create a new rule, click the "EE3VMFTbutton. Click Save when you are done. If
you edit or create a rule, the following options will appear:
Name: Enter a name for the rule.
Source IP Address
Range:
Enter the source IP address range that the rule will apply to, and using
the drop-down menu, specify whether it is a 8"/ or -"/ IP address.
Destination IP
Address Range:
Enter the destination IP address range that the rule will apply to, and
using the drop-down menu, specify whether it is a 8"/ or -"/ IP
address.
Port Range: Select the protocol of the trac to allow or deny ("OZ, TCP, or UDP)
and then enter the range of ports that the rule will apply to.
Schedule: Use the drop-down menu to select the time schedule that the rule
will be enabled on. The schedule may be set to "MXBZT&OBCMF, or
you can create your own schedules in the Schedules section. Refer
to Refer to Schedule on page 81 for more information.
Click Save when you are done.