DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
To create a new VLAN, click the ADD button ( ).
Figure 105. The page for adding a VLAN.
You can specify the following parameters:
Parameter Description
Name A name for the VLAN for easier identification.
Enable
Move the switch to the right to allow using this VLAN.
Type
The type of the VLAN.
• Untagged NAT: The VLAN of this type is an external
connection with address translation. It is mostly used to
transmit untagged traffic. When this value is selected, the
VLAN ID field and the Tagged Ports section are not
displayed. Only one VLAN of this type can exist in the
system.
• Tagged NAT: The VLAN of this type is an external
connection with address translation. It is mostly used to
connect to the Internet. Later the network which identifier is
specified in the VLAN ID field is used as an interface to
create a WAN connection (on the Connections Setup /
WAN page). When this value is selected, the Untagged
Ports section is not displayed.
• Bridge: The VLAN of this type is a transparent connection
between an internal port and an external connection. It is
mostly used to connect IPTV set-top boxes.
Page 125 of 175
To Next Page
Loading...
