DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
ALG/Passthrough
This page is available if the Router or WISP Repeater mode was selected in the Initial
Configuration Wizard.
On the Advanced / ALG/Passthrough page, you can allow the access point to use RTSP, enable
the SIP ALG and PPPoE/PPTP/L2TP/IPsec pass through functions.
SIP is used for creating, modifying, and terminating communication sessions. This protocol allows
telephone calls via the Internet.
RTSP is used for real-time streaming multimedia data delivery. This protocol allows some
applications to receive streaming audio/video from the Internet.
The PPPoE pass through function allows PPPoE clients of computers from your LAN to connect to
the Internet through connections of the access point.
The PPTP pass through, L2TP pass through and IPsec pass through functions allow VPN PPTP,
L2TP and IPsec traffic to pass through the access point so that clients from your LAN can establish
relevant connections with remote networks.
Figure 118. The Advanced / ALG/Passthrough page.
Page 140 of 175
To Next Page
Loading...
