DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
Configuring WAN Connection
This configuration step is available for the Router and WISP Repeater modes.
!
You should configure your WAN connection in accordance with data provided by your
Internet service provider (ISP). Make sure that you have obtained all necessary information
prior to configuring your connection. Otherwise contact your ISP.
1. On the Internet connection type page, from the Connection type list, select the
connection type used by your ISP and fill in the fields displayed on the page.
2. Specify the settings necessary for the connection of the selected type.
3. If your ISP uses MAC address binding, select the Clone MAC address of your device
checkbox.
4. If the Internet access is provided via a VLAN channel, select the Use VLAN checkbox and
fill in the VLAN ID field.
5. Click the NEXT button to continue or click the BACK button to return to the previous page.
Page 51 of 175
To Next Page
Loading...
