DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
URL Filter
On the Firewall / URL Filter page, you can specify restrictions on access to certain web sites.
Figure 124. The Firewall / URL Filter page.
To enable the URL filter, in the General Settings section, move the Enable switch to the right,
then select the needed mode from the Type drop-down list:
• Block listed URLs: when this value is selected, the access point blocks access to all
addresses specified in the Filters section;
• Block all URLs except listed: when this value is selected, the access point allows access
to addresses specified in the Filters section and blocks access to all other web sites.
Click the APPLY button.
To specify URL addresses to which the selected filtering mode will be applied, in the Filters
section, click the ADD RULE button and enter a relevant address in the displayed line. Then click
the APPLY button.
To remove an address from the list of URL addresses, click the Delete icon ( ) in the line of the
relevant URL address. Then click the APPLY button.
Page 150 of 175
To Next Page
Loading...
