DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
Local Update
!
Attention! Do not turn off the access point before the firmware update is completed. This
may cause the device breakdown.
To update the firmware of the access point locally, follow the next steps:
1. Download a new version of the firmware from www.dlink.ru.
2. Click the CHOOSE FILE button in the Local Update section on the System /
Firmware Update page to locate the new firmware file.
3. Click the UPDATE FIRMWARE button.
4. Wait until the access point is rebooted (about one and a half or two minutes).
5. Log into the web-based interface using the login (admin) and the current password.
If after updating the firmware the access point doesn't work correctly, please restore the factory
default settings. To do this, click the Factory button on the System / Configuration page. Wait
until the access point is rebooted.
Page 155 of 175
To Next Page
Loading...
