DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
UDPXY
This page is available if the Router or WISP Repeater mode was selected in the Initial
Configuration Wizard.
On the Advanced / UDPXY page, you can allow the access point to use the built-in UDPXY
application. The UDPXY application transforms UDP traffic into HTTP traffic. This application
allows devices which cannot receive UDP streams to access stream video.
Figure 115. The Advanced / UDPXY page.
To enable the application, move the Enable switch to the right.
Upon that the following fields are displayed on the page:
Parameter Description
Port The port of the access point which the UDPXY application uses.
Maximum client number
Maximum number of devices from the access point's LAN which
will be served by the application.
Buffer size for incoming
data
Size of intermediate buffer for received data.
By default, the minimum acceptable value is specified.
Buffer size for data
transferred to client
Size of intermediate buffer for transmitted data.
By default, the minimum acceptable value is specified.
WAN interface
From the drop-down list, select a WAN connection which will be
used for operation with streaming video.
After specifying the needed parameters, click the APPLY button.
Page 137 of 175
To Next Page
Loading...
