DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
TR-069 Client
This page is available if the Router or WISP Repeater mode was selected in the Initial
Configuration Wizard.
On the Advanced / TR-069 Client page, you can configure the access point for communication
with a remote Auto Configuration Server (ACS).
The TR-069 client is used for remote monitoring and management of the device.
Figure 111. The page for configuring the TR-069 client.
You can specify the following parameters:
Parameter Description
TR-069 Client
Interface
The interface which the access point uses for communication with
the ACS. Leave the Automatic value to let the device select the
interface basing on the routing table or select another value if
required by your ISP.
Enable TR-069 Сlient Move the switch to the right to enable the TR-069 client.
Page 132 of 175
To Next Page
Loading...
