DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
IGMP
This page is available if the Router or WISP Repeater mode was selected in the Initial
Configuration Wizard.
On the Advanced / IGMP page, you can allow the access point to use IGMP.
IGMP is used for managing multicast traffic (transferring data to a group of destinations). This
protocol allows using network resources for some applications, e.g., for streaming video, more
efficiently.
Figure 117. The Advanced / IGMP page.
The following elements are available on the page:
Parameter Description
Enable Move the switch to the right to enable IGMP.
IGMP version
Select a version of IGMP from the drop-down list.
Interface
From the drop-down list, select a connection of the Dynamic IPv4 or
Static IPv4 type for which you need to allow multicast traffic (e.g.
streaming video).
After specifying the needed parameters, click the APPLY button.
Page 139 of 175
To Next Page
Loading...
