DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
In the opened window, you can specify the following parameters:
Parameter Description
IP version
An IP version to which the rule will be applied. Select the relevant
value from the drop-down list.
Open access from any
external host
Move the switch to the right to allow access to the access point for
any host. Upon that the IP address and Mask fields are not
displayed.
IP address
A host or a subnet to which the rule is applied. You can specify an
IPv4 or IPv6 address.
Mask
For the IPv4-based network only.
The mask of the subnet.
Public port
For the IPv4-based network only.
An external port of the access point. You can specify only one port.
Protocol The protocol available for remote management of the access point.
After specifying the needed parameters, click the SAVE button.
To edit a rule for remote access, left-click the relevant rule. In the opened window, change the
needed parameters and click the SAVE button.
To remove a rule for remote access, select the checkbox located to the left of the relevant line in the
table and click the DELETE button ( ).
Page 135 of 175
To Next Page
Loading...
