DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
4. Click the APPLY button. The System date and System time fields will be filled in
automatically.
To enable the access point to automatically adjust to daylight saving time, move the Daylight
saving time switch to the right. From the Daylight saving time zone drop-down list, select the
time zone that will be used during summer time and specify the needed values in the Beginning of
daylight saving time and End of daylight saving time sections. Click the APPLY button.
In some cases NTP servers addresses are provided by your ISP. In this case, you need to move the
Get NTP server addresses using DHCP switch to the right and click the APPLY button.
Contact your ISP to clarify if this setting needs to be enabled. If the Get NTP server addresses
using DHCP switch is moved to the right, the NTP Servers section is not displayed.
To allow connected devices to use the IP address of the access point in the local subnet as a time
server, move the Run as a server for the local network switch to the right and click the
APPLY button.
!
When the access point is powered off or rebooted, the system time is reset to the default
value. If you have set automatic synchronization for the system time, the internal clock of
the device will be configured after connecting to the Inter net. If you have set the system
time manually, you need to set the time and date again (see above).
Page 166 of 175
To Next Page
Loading...
