DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Installation and Connection
6. Select the Use the following IP address radio button and enter the value
192.168.0.51 in the IP address field. The Subnet mask field will be filled in
automatically. Click the OK button.
Figure 10. The Internet Protocol Version 4 (TCP/IPv4) Properties window.
7. Click the OK button in the connection properties window.
Now you can connect to the web-based interface of DAP-300P for configuring all needed
parameters. To gain access to an external network (to the Internet), you also need to specify the
default gateway and the addresses of DNS servers.
Page 24 of 175
To Next Page
Loading...
