D-Link DAP-300P - Page 73

DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
Parameter Description
Local IP Address
Mode of local IP
address assignment
For the Access point, Repeater, and Client modes only.
Select the needed value from the drop-down list.
• Static: the IP address, subnet mask, and the gateway IP
address are assigned manually.
• Dynamic: the access point automatically obtains these
parameters from the LAN DHCP server or from the router to
which it connects.
IP address
The IP address of the access point in the local subnet. By default, the
following value is specified: 192.168.0.50.
Mask
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
Gateway IP address
For the Access point, Repeater, and Client modes only.
The gateway IP address which is used by the access point to connect
to the Internet (e.g., for synchronizing the system time with an NTP
server). Optional.
Hostname
The name of the device assigned to its IP address in the local subnet.
Figure 64. Configuring the local interface. The IPv4 tab. The Dynamic IP Addresses section.
Page 73 of 175