DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
Figure 73. The page for creating a new Static IPv4 connection. The Ethernet section.
Parameter Description
Ethernet
MAC address
A MAC address assigned to the interface. This parameter is
mandatory if your ISP uses MAC address binding. In the field, enter
the MAC address registered by your ISP upon concluding the
agreement.
To set the MAC address of the network interface card (of the
computer that is being used to configure the access point at the
moment) as the MAC address of the WAN interface, move the
Clone MAC address of your NIC switch to the right. When the
switch is moved to the right, the field is unavailable for editing.
To set the access point's MAC address, click the RESTORE
DEFAULT MAC ADDRESS button (the button is available when
the switch is moved to the right).
MTU
The maximum size of units transmitted by the interface.
Page 82 of 175
To Next Page
Loading...
