DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
Parameter Description
Basic connection
From the drop-down list, select a WAN connection which will be
used as the main one.
Backup connection
From the drop-down list, select a WAN connection which will be
used as the reserve one.
Test host
An IP address that the access point will check for availability via
ICMP ping mechanism.
Check interval
A time period (in seconds) between attempts to check the status of
the main connection. By default, the value 10 is specified.
Timeout check
A time period (in seconds) for an attempt to check the status of the
main connection. At the end of this period the access point's internal
system makes a decision to enable/disable the reserve channel. By
default, the value 3 is specified.
Number of inspections
of active connection
A number of requests that will be sent in order to analyze the status
of the main connection when the connection is active (the access
point uses the main connection as a default gateway).
Number of inspections
of inactive connection
A number of requests that will be sent in order to analyze the status
of the main connection when the connection is inactive (the access
point uses the reserve connection as a default gateway).
When all needed settings are configured, click the APPLY button.
Page 91 of 175
To Next Page
Loading...
