27D-Link DCS-2670L User Manual
Section 3: Conguration
Enable UPnP Port
Forwarding:
HTTP Port:
Access Name for
Stream 1~3:
HTTPS Port:
RTSP Port:
Enable CoS:
Enable QoS:
Enable IPv6:
Enabling this setting allows the camera to add port forwarding entries
into the router automatically on a UPnP capable network.
Enter the port to use for HTTP access to the camera. The default port
number is 80.
Enter a name to use for HTTP streaming access. The default name is
video#.mjpeg, where # is the number of the stream.
Enter the port to use for HTTPS access to the camera. You may use a PC
with a secure browser to connect to the HTTPS port of the camera. The
default port number is 443.
Enter the port number to use for RTSP streaming to mobile devices.
The default port number is 554. You may specify the address of
a particular stream. For instance, live1.sdp can be accessed at
rtsp://x.x.x.x/live1.sdp where the x.x.x.x represents the IP address of
your camera.
Enabling CoS allows you to specify the Class of Service for dierent
types of trac so you can prioritize their transmission on your network.
CoS helps provide prioritization for Layer 2 trac.
Enabling QoS allows you to specify the Quality of Service for dierent
types of trac so you can prioritize their transmission on your network.
QoS helps provide prioritization for Layer 3 trac. If the camera is
connected to a router that itself implements QoS, the router's settings
will override the QoS settings of the camera.
Select Enable IPv6 to automatically get an IPv6 address from your
router. If you have a static or xed IP from your network administrator,
To Next Page
Loading...
Need help?
General
Weight and Dimensions
