31D-Link DCS-2670L User Manual
Section 3: Conguration
Image Setup
In this section, you can congure the video image settings for your camera.
Enable Privacy Mask
Setting:
Mirror:
Flip:
Anti Flicker:
White Balance:
Exposure Mode:
The Privacy Mask setting allows you to specify up to 3 rectangular areas
on the camera's image to be blocked/excluded from recordings and
snapshots.
You may click and drag the mouse cursor over the camera image to
draw a mask area. Right clicking on the camera image brings up the
following menu options:
• Disable All: Disables all mask areas
• Enable All: Enables all mask areas
• Reset All: Clears all mask areas.
This will mirror the image horizontally.
This will ip the image vertically. If the camera is installed upside down,
Flip and Mirror should both be checked.
Select the frequency used by your power lines to avoid interference or
distortion.
Use the drop-down box to change white balance settings to help
balance colors for dierent environments. You can choose from Auto,
Outdoor, Indoor, and Fluorescent.
Changes the exposure mode. Use the drop-down box to set the camera
for Outdoor, Indoor, or Night environments, or set to Moving to
capture moving objects. The Low Noise option will focus on creating
a high-quality picture with reduced noise when monitoring low-light
environments. You can also create 3 dierent custom exposure modes
that let you set the minimum and maximum shutter speeds. The Max
Gain setting will allow you to control the maximum amount of gain to
apply to brighten the picture.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
