D-Link DCS-2670L

26D-Link DCS-2670L User Manual
Section 3: Conguration
Network Setup
Use this section to congure the network connections for your camera. All relevant information must be entered accurately. After making your
changes, click the Save Settings button for them to take eect.
LAN Settings:
DHCP:
Static IP Client:
IP Address:
Subnet Mask:
Default Router:
Primary DNS:
Secondary DNS:
Enable UPnP
Presentation:
This section lets you congure settings for your local area network.
Select this connection if you have a DHCP server running on
your network and would like your camera to obtain an IP address
automatically.
If your network uses a xed routes, you may need to obtain a xed IP
address from your network administrator for your camera. A static IP
address may simplify access to your camera in the future.
Enter the IP address that the camera will use on your network. You may
need to get this information from your network administrator.
Enter the subnet mask that your camera will use on the network.
The default value is “255.255.255.0.” This is used to determine if the
destination is part of the same subnet.
Enter the address of the router or gateway your camera will use on the
network. The gateway is used to forward frames to destinations in a
dierent subnet. Invalid gateway settings may cause transmissions to a
dierent subnet to fail.
Enter the primary domain name server that translates names to IP
addresses.
Enter the secondary domain name server used to back up the Primary
DNS.
Enabling this setting allows your camera to be congured as a UPnP
device on your network.