D-Link DCS-2670L - System Configuration and Firmware Upgrade

49D-Link DCS-2670L User Manual
Section 3: Conguration
System
In this section, you may backup, restore and reset the camera conguration, or reboot the camera.
Save To Local Hard
Drive:
Load From Local
Hard Drive:
Restore to Factory
Defaults:
Reboot Device:
Enable Schedule
Reboot:
You may save your current camera conguration as a le on your
computer.
Locate a pre-saved conguration by clicking Browse and then restore
the pre-dened settings to your camera by clicking Load Conguration.
You may reset your camera and restore the factory settings by clicking
Restore Factory Defaults.
This will restart your camera.
If you want your camera to reboot on a regular schedule, check the
Enable Schedule Reboot checkbox, then select the days and time you
want the camera to reboot.