D-Link DCS-5222L - Internet Connection Setup Wizard

25D-Link DCS-5222L User Manual
Section 4 - Conguration
Internet Connection Setup Wizard
This wizard will guide you through a step-by-step process to
congure your new D-Link Camera and connect the camera to the
Internet. Note that this wizard will not register your camera with
mydlink.com.
Click Next to continue.
Select DHCP if you want your DHCP server (usually enabled on your
router) to assign the camera its IP settings. If you want to manually
assign the IP settings, select Static IP Address and enter the following
details:
Enter an IP address for your camera.
Enter the subnet mask of your network.
Enter the default gateway address. This is
usually the IP address of your router.
Enter the primary DNS server’s IP address. This
is usually the IP address of your router.
Enter the secondary DNS server’s IP address.
This is optional.
If you are required to connect using PPPoE,
select Enable PPPoE and enter the Username
and Password for your PPPoE connection. Only
select this option if your camera is directly
connected to your broadband modem. If it is
on a network with a router or gateway, do not
select this option.
Click Next to continue.
IP Address:
Subnet Mask:
Default Gateway:
Primary DNS:
Secondary DNS: