96
create snmp community
Description
This command is used to create an SNMP
community string and to assign access-limiting
characteristics to this community string.
Parameters <community_string 20> - An alphanumeric
string of up to 20 characters that is used to
identify members of an SNMP community. This
string is used like a password to give remote
SNMP managers access to MIB objects in the
Switch’s SNMP agent.
read_only - Specifies that SNMP community
members using the community string created
with this command can only read the contents of
the MIBs on the Switch.
read_write - Specifies that SNMP community
members using the community string created
with this command can only read from and write
to the contents of the MIBs on the Switch.
Example usage:
To create the SNMP community string “admin”:
Figure 88. create snmp community command
To Next Page
Loading...
