Parameters <ipaddress> - The IP address of the remote
management station that will serve as the SNMP
host for the Switch.
<vlan_id> - Specific the 802.1Q VLAN ID of the
SNMP recipient host. The range is between 1 to
4094.
trap_community <community_string> - An
alphanumeric string of up to 20 characters used
to authorize a remote SNMP manager to access
the Switch’s SNMP agent.
Example usage:
To create an SNMP host to receive SNMP messages:
Figure 91. create snmp host command
show snmp host
Purpose
Used to display the recipient of SNMP traps
generated by the Switch’s SNMP agent.
Syntax show snmp host
Description
This command is used to display the IP
addresses and configuration information of
remote SNMP managers that are designated as
recipients of SNMP traps that are generated by
the Switch’s SNMP agent.
Parameters
None.
99
To Next Page
Loading...
