MIBs
Management and counter information are stored by the Switch in the
Management Information Base (MIB). The Switch uses the standard
MIB-II Management Information Base module. Consequently, values
for MIB objects can be retrieved from any SNMP-based network
management software. In addition to the standard MIB-II, the Switch
also supports its own proprietary enterprise MIB as an extended
Management Information Base. The proprietary MIB may also be
retrieved by specifying the MIB Object Identifier. MIB values can be
either read-only or read-write.
Enabled / Disabled: To selecting enable or disable SNMP function
on the Switch.
SNMP Community / Trap: To configure the SNMP Community or
SNMP Trap configuration.
Configure SNMP Community:
Figure 27. SNMP Community Setting
41
To Next Page
Loading...
