Add Group: To add a SNMP Community group, press “Add Group”
button, the Add SNMP Community configuration window will pop
out; fill in the community name and assign the community enable
read_only or read_write. Press “Apply” button to execute the setting.
Figure 28. Add SNMP Community group
Delete Group: To delete previously defined SNMP Community
group, press “Delete Group” button, the Delete SNMP Community
configuration window will pop out; checked the delete dialog box.
Press “Apply” to delete the selected SNMP Community Group.
Figure 29. Delete SNMP Community group
42
To Next Page
Loading...
