DES-3550 Layer 2 Fast Ethernet Switch
config snmp system_contact
Purpose Used to enter the name of a contact person who is responsible for the Switch.
Syntax
config snmp system_contact{<sw_contact>}
Description The config snmp system_contact command is used to enter the name and/or
other information to identify a contact person who is responsible for the
Switch. A maximum of 255 character can be used.
Parameters <sw_contact> - A maximum of 255 characters is allowed. A NULL string is
accepted if there is no contact.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the Switch contact to “
MIS Department II
”:
DES-3550:4#config snmp system_contact MIS Department II
Command: config snmp system_contact MIS Department II
Success.
DES-3550:4#
config snmp system_location
Purpose Used to enter a description of the location of the Switch.
Syntax
config snmp system_location {<sw_location>}
Description The config snmp system_location command is used to enter a description of
the location of the Switch. A maximum of 255 characters can be used.
Parameters <sw_location> - A maximum of 255 characters is allowed. A NULL string is
accepted if there is no location desired.
Restrictions Only administrator-level users can issue this command.
58
To Next Page
Loading...
