D-Link DGS-1210-16 - SNMP > RMON > RMON History; SNMP > RMON > RMON Alarm

Configuration D-Link Web Smart Switch User Manual
9
9
8
8
Owner: Displays the RMON station or user that requested the RMON information.
Click Add to create a new entry. Click Refresh to renew the table information. Click Delete to remove the
corresponding entry.
SNMP > RMON > RMON History
The RMON History Control Configuration window contains information about samples of data taken from
ports. For example, the samples may include interface definitions or polling periods.
Figure 4.120 – SNMP > RMON > RMON History Control Settings
The History Control Configuration contains the following fields:
Index (1 ~ 65535): Indicates the history control entry number.
Port: Specifies the port from which the RMON information was taken.
Buckets Requested (1 - 50): Specifies the number of buckets that the device saves.
Interval (1 - 3600): Indicates in seconds the time period that samplings are taken from the ports. The field
range is 1-3600.
Owner: Displays the RMON station or user that requested the RMON information.
Click Add to create a new entry. Click Delete to remove the corresponding entry.
SNMP > RMON > RMON Alarm
The RMON Alarm Settings window allows the user to configure the network alarms. Network alarms occur
when a network problem, or event, is detected.
Figure 4.121 – SNMP > RMON > RMON Alarm Settings
The configuration contains the following fields:
Index (1 ~ 65535): Indicates the RMON alarm entry number.
Variable: Specify the selected MIB variable value.
Rising Threshold (0 ~ 2^31-1): Displays the rising counter value that triggers the rising threshold alarm.
Rising Event Index (1 ~ 65535): Displays the event that triggers the specific alarm. The possible field
values are user defined RMON events.
Owner: Displays the device or user that defined the alarm.