D-Link DGS-1210-16 - Appendices; Ethernet Technology Overview

Configuration D-Link Web Smart Switch User Manual
6
6
2
2
Default Gateway: Enter the IPv6 default gateway address here.
Metric: Enter the metric value for this route here.
Click Create to create a new IPv6 route. Click Delete to remove the corresponding route.
L3 Functions > IPv6 Neighbor Settings
The IPv6 Neighbor Settings window allows users to configure the IPv6 neighbor settings for this Switch.
Figure 4.71 – L3 Functions > IPv6 Neighbor Settings
Interface Name: Enter the neighbor IPv6 interface name here.
Neighbor IPv6 Address: Enter the neighbor IPv6 address here.
VID: Enter the neighbor IPv6 VLAN ID here.
Link Layer MAC Address: Enter the neighbor IPv6 link layer MAC address here.
Click Add to create a new IPv6 neighbor entry.
Interface Name: Enter the neighbor IPv6 interface name here.
State: Select and enter the neighbor IPv6 state here. Options to choose from are All, Address, Static, and
Dynamic.
Click Find to locate the IPv6 neighbor.
Click Clear to remove the entries displayed in the table.
L3 Functions > DHCP > DHCP Relay Settings
This window contains two main parts, DHCP Relay Global Settings and DHCP Relay Interface Settings.
In DHCP Relay Global Settings, users can enable and configure DHCP Relay Global Settings. The relay
hops count limit allows the maximum number of hops (routers) that the DHCP messages can be relayed
through to be set. The DHCP packet will be dropped when the relay hop count in the received packet is
equal to or greater than this setting. The relay time threshold sets the minimum time (in seconds) that the
Switch will wait before forwarding a BOOTREQUEST packet. If the value in the seconds’ field of the packet
is less than the relay time threshold, the packet will be dropped.
In DHCP Relay Interface Settings, users can set up a server, by IP address, for relaying DHCP information
to the Switch. Properly configured settings will be displayed in the DHCP Relay Interface Table at the bottom
of the window, once the user clicks the Add button. The user can only add one server IP for the System
interface on the Switch. Entries may be deleted by clicking the corresponding Delete button.