Configuration D-Link Web Smart Switch User Manual
6
6
4
4
DHCPv6 Relay Hops Count Limit (1-32): This field allows an entry between 1 and 32. If the message
received by the relay agent is a Relay-forward message and the hop-count in the message is greater than or
equal to the Relay Hops Count Limit, the relay agent discards the received message. The default hop count
is 4.
Click Apply to implement the changes made.
DHCPv6 Relay Interface Settings:
Interface Name: The IPv6 interface on the Switch that will be connected directly to the client.
Server IPv6 Address: Enter the IPv6 address of the DHCPv6 server.
Click Add to create the information and display the information in the table below. Click Delete to remove the
corresponding entry.
QoS > Bandwidth Control
The Bandwidth Control window allows network managers to define the bandwidth settings for a specified
port’s transmitting and receiving data rates.
Figure 4.74 – QoS > Bandwidth Control
From Port / To Port: A consecutive group of ports may be configured starting with the selected port.
Type: This drop-down menu allows you to select between RX (receive), TX (transmit), and Both. This setting
will determine whether the bandwidth ceiling is applied to receiving, transmitting, or both receiving and
transmitting packets.
No Limit: This drop-down menu allows you to specify that the selected port will have no bandwidth limit.
Enabled disables the limit.
Rate (15-1024000): This field allows you to enter the data rate, in Kbits per second, will be the limit for the
selected port. The value is between 15 and 1024000.
Click Apply to set the bandwidth control for the selected ports.
To Next Page
Loading...
