Configuration D-Link Web Smart Switch User Manual
6
6
6
6
When ToS is selected in Select QoS Mode, the following selections appear.
From ToS / To ToS: Select a consecutive ToS.
Priority: Defines the priority assigned to the port. The priorities are Highest, High, Medium and Low.
Click Apply for the settings to take effect.
QoS > IPv6 Traffic Class Priority Settings
The IPv6 Traffic Class Priority Settings window allows users to configure the IPv6 traffic class priority
settings.
Figure 4.76 – QoS > IPv6 Traffic Class Priority Settings
IPv6 Traffic Class: Enter the IPv6 traffic class value here. This value must be between 0 and 255.
Priority: Defines the priority assigned to the class. The priorities are Highest, High, Medium and Low.
Click Apply for the settings to take effect.
QoS > TCP/UDP Port Priority Settings
The TCP/UDP Port Priority Settings window allows user to configure the port priority.
Figure 4.77 – QoS > TCP/UDP Port Priority Settings
TCP/UDP: Specify port priority of TCP or UDP to be configured.
TCP/UDP Port (0-65535): Specify the TCP or UDP port.
Priority: Defines the priority assigned to the port. The priorities are Highest, High, Medium and Low.
Click Apply for the settings to take effect.
Security > Trusted Host
Use Trusted Host function to manage the switch from a remote station. You can enter up to ten designated
management stations networks by defining the IPv4 Address/Netmask or the IPv6 Address/Prefix as seen in
the figure below. The first thing after the function is enabled is to add your local host IP address as a trusted
host. Otherwise, you may lose the connection.
To Next Page
Loading...
