D-Link DGS-1210-16 - Upload

Command Line Interface D-Link Web Smart Switch User Manual
1
1
0
0
6
6
Restrictions None.
Example usage:
To download a firmware file:
DGS-1210-24:admin#download firmware_fromTFTP 10.90.90.10 RUNTIME
Connecting to server................... Done.
Download firmware...................... Done. Do not power off!
Please wait, programming flash......... Done.
DGS-1210-24:admin#
Note: Switch will reboot after the restore
and all current configurations will be lost.
upload
Purpose This command is used to upload the firmware file or a Switch
configuration file to a TFTP server.
Syntax
upload [cfg_toTFTP [<ipaddr> | <ipv6addr>] <path_filename
64> | firmware_toTFTP [<ipaddr> | <ipv6addr>] <path_filename
64>]
Description
The upload command uploads the Switch’s current settings to a
TFTP server.
Parameters
cfg_toTFTP − Specifies that the Switch’s current settings will be
uploaded to the TFTP server.
<ipaddr> − Enter the IPv4 address of the TFTP server.
<ipv6addr> − Enter the IPv6 address of the TFTP server.
<path_filename> − Enter the filename of the firmware or switch
configuration file to be saved on the TFTP server. You need to
specify the DOS path if the file is not to be saved in the root
directory of the TFTP server.
firmware_toTFTP – Specifies to upload the firmware on the Switch
to a TFTP server.
<ipaddr> − Enter the IPv4 address of the TFTP server.
<ipv6addr> − Enter the IPv6 address of the TFTP server.
<path_filename> − Enter the filename of the firmware or switch
configuration file to be saved on the TFTP server. You need to
specify the DOS path if the file is not to be saved in
the root
directory of the TFTP server.
Restrictions None.
Example usage:
To upload a firmware file: