Command Line Interface D-Link Web Smart Switch User Manual
1
1
0
0
7
7
DGS-1210-24:admin#upload firmware_toTFTP 10.90.90.10 RUNTIME
Connecting to server................... Done.
Upload firmware........................ Done.
DGS-1210-24:admin#
config ipif System
Purpose This command is used to configure the System IP interface.
Syntax
config ipif System [ipaddress <ip-address> <subnet-mask>
gateway <gw-address> | dhcp | bootp | ipv6 ipv6address
<ipv6networkaddr> | dhcpv6_client {enable | disable}]
Description
The config ipif System
command configures the System IP
interface on the Switch.
Parameters
ipaddress <ip-address> <subnet-mask> − Specifies the IPv4
address and subnet mask to be created. Users need to specify the
IPv4 address and subnet mask information using the traditional
format (For example, 10.1.2.3/255.0.0.0).
gateway <gw-address> − Specifies the IP address of the router or
gateway.
dhcp −
Allows the selection of the DHCP protocol for the
assignment of an IP address to the Switch’s System IP interface.
bootp − Allows the selection of the BOOTP to the Switch.
ipv6 ipv6address <ipv6networkaddr> - Specifies the IPv6 address
and network address to be created.
dhcpv6_client {enable | disable} – Specifies to enable or disable
the DHCPv6 client feature.
Restrictions None.
Example usage:
To configure the IP interface System:
DGS-1210-24:admin#config ipif System ipaddress 10.90.90.2 255.0.0.0 gateway
10.90.90.1
Success.
DGS-1210-24:admin#
Purpose This command is used to logout a user from the Switch’s
Command Line Interface.
Syntax
logout
Description
The logout command terminates the current user’s session from
the Switch’s console.
Parameters None.
Restrictions None.
Example usage:
To Next Page
Loading...
