Configuration D-Link Web Smart Switch User Manual
9
9
2
2
PoE > PoE Global Settings (DGS-1210-08P/24P only)
This page will display the PoE status including System Budget Power, Support Total Power, Remainder
Power, and The ratio of system power supply.
Figure 4.109 – PoE > PoE Global Settings
PoE Power Threshold: Manually configure the system’s power budget.
Power Shut Off Sequence: Defines the method used to deny power to a port once the threshold is reached.
The possible fields are:
Deny next port: When the power budget is exceeded, the next port attempting to power up is
denied, regardless of the port priority.
Deny low priority port: The port with the lower priority will be shut down to allow the higher priority
port to power up.
Click Apply to make the configurations take effects.
System Power Status: Displays the system power status of device.
Total PoE Power Budget: Displays the total PoE power budget of this switch.
Power Used: Displays the current used power of the switch.
Power Left: Displays the spare power of the switch.
The percentage of system power supplied: Displays the percentage of power supplied by the PoE.
PoE > PoE Port Settings (DGS-1210-08P/24P only)
The DGS-1210-24P supplies power to PD devices up to 30 Watt for ports 1 to 12, meeting IEEE 802.3af and
802.3at standards. The DGS-1210-08P supplies power to PD devices up to 15.4 Watt for ports 1 to 8.
The DGS-1210-24P works with all D-Link 802.3af or 802.3at capable devices. The DGS-1210-08P works
with all D-Link 802.3af devices.
IEEE 802.3at defined that the PSE provides power according to the following classification:
Class Usage Output power limit by PSE
0 Default 15.4W
1 Optional 4.0W
2 Optional 7.0W
3 Optional 15.4W
4 Reserved 30W
The PoE port table will display the PoE status including, Port Enable, Power Limit, Power (W), Voltage (V),
Current (mA), Classification, Port Status. You can select From Port / To Port to control the PoE functions of
To Next Page
Loading...
