D-Link DIR-400 - Enabling WPA, WPA2, WPA;WPA2 Wireless Security for a RADIUS Server

36D-Link DIR-400 User Manual
Section 3 - Conguration
1. To enable WPA, WPA2, or WPA/WPA2 for a RADIUS
server, next to Security Mode, select Enable WPA
Only Wireless Security (enhanced), Enable WPA2
Only Wireless Security (enhanced), or Enable
WPA/WPA2 Wireless Security (enhanced).
2. Next to Cipher Type, select TKIP, AES, or Auto.
3. Next to PSK/EAP, select EAP.
4. Next to RADIUS Server 1 enter the IP Address
of your RADIUS server.
5. Next to Port, enter the port you are using with your
RADIUS server. 1812 is the default port.
6. Next to Shared Secret, enter the security key.
7. If you have a secondary RADIUS server, enter its
IP address, port, and secret key.
8. Click Save Settings to save your settings.
Note: When using EAP mode, you cannot have WPS
enabled.
Enabling WPA, WPA2, WPA/WPA2 Wireless Security for a RADIUS Server