D-Link DIR-400 - Setting Up a Configured Router

79D-Link DIR-400 User Manual
Section 6 - Setting Up Wi-Fi Protection (WCN 2.0 in Windows Vista)
Setting Up a Configured Router
Once the router has been congured, you can use the push button on the router or in the third party software interface
to invite a newcomer to join your Wi-Fi protected network. For maximum security, the software method is recommended.
However, the push button method is ideal if there is no access to a GUI.
If you are using the router’s Wi-Fi Security push button option, press the Wi-Fi Protected Setup button on the side of
the router, then push the button on the client (or virtual button on the client’s GUI) within 2 minutes. Next click Finish.
The Client’s software will then allow a newcomer to join your secure, Wi-Fi protected network.
If you are using third party software, run the appropriate Wi-Fi Protected System utility. You will be asked to either
use the push button method or to manually enter the PIN. Follow the on-screen instructions to nish setting up your
connection.