D-Link DIR-400 - Setting Up Wi-Fi Protection (WCN 2.0 in Windows Vista); Initial Router Configuration for Wi-Fi Protection

78D-Link DIR-400 User Manual
Section 6 - Setting Up Wi-Fi Protection (WCN 2.0 in Windows Vista)
Setting Up Wi-Fi Protection
(WCN 2.0 in Windows Vista)
The DIR-400 supports Wi-Fi protection, referred to as WCN 2.0 in Windows Vista. The instructions for setting this up
depend on whether you are using Windows Vista or third party software to congure the router.
Initial Router Configuration for Wi-Fi Protection
When you rst set up the router, Wi-Fi protection is disabled and uncongured. To enjoy the benets of Wi-Fi protection,
the router must be both enabled and congured. There are three basic methods to accomplish this: use Windows Vista’s
built-in support for WCN 2.0, use software provided by a third party, or use the traditional Ethernet approach.
If you are running Windows Vista, tick the Enable checkbox on the Wireless Network window. You can choose to use
the Current PIN that is displayed on the Wireless Network window, randomly create a new PIN by clicking Generate
New PIN, or click on Reset PIN to Default to use the default PIN.
If you are using third party software to set up Wi-Fi Protection, carefully follow the directions provided with the software.
When you are nished, proceed to the next section to set up the newly-congured router.