D-Link DIR-803 - Ipv6 in Ipv4 Tunneling

62D-Link DIR-803 User Manual
Section 3 - Conguration
IPv6 in IPv4 Tunneling
Select IPv6 in IPv4 Tunnel from the drop-down menu.
Enter the settings supplied by your Internet Service Provider (ISP).
Select either Obtain IPv6 DNS Servers automatically or Use
the following IPv6 DNS Servers.
If you selected the second option above, enter the Primary and
Secondary DNS Server addresses.
Check this box to Enable DHCP prex delegation.
Enter the LAN (local) IPv6 Address for the router.
Displays the Router’s LAN IPv6 Link-Local Address.
Check to enable the Autoconguration feature.
Check to enable delegation of prexes for router addresses.
Select Stateful (DHCPv6), SLAAC + RDNSS or SLAAC + Stateless
DHCP.
Enter the start IPv6 Address for the DHCPv6 range for your local
computers.
Enter the end IPv6 Address for the DHCPv6 range for your local
computers.
Enter the Router Advertisement Lifetime (in minutes).
My IPv6 Connection is:
IPv6 in IPv4 Tunnel
Settings:
IPv6 DNS Settings:
Primary/Secondary
IPv6 DNS Servers:
Enable DHCP-PD:
LAN IPv6 Address:
LAN IPv6 Link-Local
Address:
Enable Automatic IPv6
address assignment:
Enable Automatic
DHCP-PD in LAN:
Autoconguration
Type:
IPv6 Address Range
Start:
IPv6 Address Range
End:
Router Advertisement
Lifetime: