D-Link DIR-803 - Advanced; Virtual Server

66D-Link DIR-803 User Manual
Section 3 - Conguration
If you disable UPnP™ (Universal Plug and Play), you will need to manually open ports or set up application rules for certain applications. Refer to
your application’s documentation or website for port information. The Virtual Server will allow you to open a single port. To open a range of ports,
refer to Port Forwarding on the next page. Application Rules are covered on the page that follows.
Enter a Name for the rule or select an Application name
from the drop-down menu. When an Application
Name is selected click << to populate the eld.
Enter the IP Address of the computer on your
local network that you want to allow the incoming
service to. If your computer is receiving an IP address
automatically from the router (DHCP), you computer
will be listed in the Computer Name drop-down
menu. Select your computer and click <<.
Enter the port(s) that you want to open in the elds
below Private Port and Public Port. The private and
public ports are usually the same. The public port is
the port seen from the Internet side, and the private
port is the port being used by the application on the
computer within your local network.
Select TCP, UDP, or Both from the drop-down menu.
The schedule of time when the Virtual Server Rule will
be enabled. The schedule may be set to Always, which
allows the service to always be enabled. You can create
your own schedule in the Tools > Schedules section.
Select Allow All (most common) or a pre-dened
Inbound lter. You may create your own inbound
lters in the Advanced > Inbound Filter page.
Name:
IP Address:
Private Port/
Public Port:
Protocol:
Schedule:
Inbound Filter:
Virtual Server
Advanced