D-Link DIR-803 - Network (MAC) Filters

71D-Link DIR-803 User Manual
Section 3 - Conguration
Network (MAC) Filters
Select Turn MAC Filtering O, Allow MAC addresses
listed below, or Deny MAC addresses listed below
from the drop-down menu.
Enter the MAC Address you would like to lter, or
select from the DHCP Client List (see below).
To nd the MAC address on a computer, please refer
to the Networking Basics section in this manual.
Devices that have obtained an IP address from the
router’s DHCP server will be in the DHCP Client List.
Select a DHCP Client from the drop-down menu and
click << to copy that device’s MAC Address.
The schedule may be set to Always, which will allow
the ltering to always be enabled. Use the drop-
down menu to select a pre-dened a schedule in the
router. Or, you can click on New Schedule to add one.
Click Save Settings.
Congure MAC
Filtering:
MAC Address:
DHCP Client List:
Schedule:
Use MAC (Media Access Control) Filters to allow or deny LAN (Local Area Network) computers by their MAC addresses from
accessing the network. You can either manually add a MAC address or select the MAC address from the list of clients that are
currently connected to the Broadband Router.