DIR-882 AC2600 Wave 2 MU-MIMO Wi-Fi Gigabit Router with
3G/LTE Support and 2 USB Ports
User Manual
Configuring via Web-based Interface
Parameter Description
Gateway IP address
Available if the Access point or Repeater mode was selected in
the Initial Configuration Wizard.
The gateway IPv4 address which is used by the router to connect to
the Internet (e.g., for synchronizing the system time with an NTP
server). Optional.
Hostname
The name of the device assigned to its IPv4 address in the local
subnet.
Figure 97. Configuring the local interface. The IPv4 tab. The Dynamic IP Addresses section.
Parameter Description
Dynamic IP Addresses
Mode of dynamic IP
address assignment
An operating mode of the router's DHCP server.
• Disable: The router's DHCP server is disabled, clients' IP
addresses are assigned manually.
• Server: The router assigns IP addresses to clients
automatically in accordance with the specified parameters.
When this value is selected, the Start IP, End IP, Lease
time fields and the DNS relay switch are displayed on the
tab. Also when this value is selected, the DHCP Options,
Static IP Addresses, and Hosts sections are displayed on
the tab.
Page 116 of 303
To Next Page
Loading...
