DIR-882 AC2600 Wave 2 MU-MIMO Wi-Fi Gigabit Router with
3G/LTE Support and 2 USB Ports
User Manual
Configuring via Web-based Interface
WPS
On the Wi-Fi / WPS page, you can enable the function for configuration of the WLAN and select a
method for connection to the WLAN.
The WPS function helps to configure the protected wireless network automatically. Devices
connecting to the wireless network via the WPS function must support the WPS function.
!
The WPS function allows adding devices only to the basic wireless network of the router.
!
Before using the function you need to configure one of the following authentication types:
Open with no encryption, WPA2-PSK or WPA-PSK/WPA2-PSK mixed with the AES
encryption method. When other security settings are specified, controls of the WPS page
on the tab of the relevant band are not available.
Figure 133. The page for configuring the WPS function.
You can activate the WPS function via the web-based interface or the hardware WPS button on the
cover of the device.
To activate the WPS function via the hardware button, move the Enable Wi-Fi when WPS
function is activated with hardware button switch to the right on the tabs of both bands.
Then, with the device turned on, push the button, hold it for 2 seconds, and release. The WLAN
2.4G and WLAN 5G LEDs should start blinking. In addition, upon pressing the button, the wireless
interfaces of the device are enabled if they were disabled before.
Page 162 of 303
To Next Page
Loading...
Need help?
General
Weight and Dimensions
