DIR-882 AC2600 Wave 2 MU-MIMO Wi-Fi Gigabit Router with
3G/LTE Support and 2 USB Ports
User Manual
Configuring via Web-based Interface
Parameter Description
Tagged traffic
Move the switch to the right to assign a tag (VLAN ID) to EoGRE
traffic and specify the needed value in the VLAN ID field displayed.
Interface
From the drop-down list, select a WAN connection through which
the tunnel will pass. Select the Default gateway value to use the
default WAN connection.
MTU The maximum size of units transmitted by the interface.
After configuring all needed settings, click the APPLY button.
To edit the parameters of an existing tunnel, in the Tunnels section, select the relevant tunnel in the
table. On the opened page, change the needed parameters and click the APPLY button.
To remove an existing tunnel, select the checkbox located to the left of the relevant line in the table
and click the DELETE button ( ).
VPN tunnels using EoGRE technology will appear in the EoGRE interfaces section on the
Advanced / VLAN page and will be automatically removed from this section after the tunnel is
deleted from the current page.
Page 148 of 303
To Next Page
Loading...
