DIR-882 AC2600 Wave 2 MU-MIMO Wi-Fi Gigabit Router with
3G/LTE Support and 2 USB Ports
User Manual
Configuring via Web-based Interface
Figure 141. The Wi-Fi / Super Mesh page.
To activate the Super Mesh function, on the tab of the relevant band, move the Enable Super
Mesh switch to the right. You can specify the following parameters:
Parameter Description
Domain
An identifier which shows that the device belongs to a certain mesh
network. This value should be the same for all devices of your mesh
network.
IPv6
If you need to use IPv6 for configuring the mesh network, move the
IPv6 switch to the right.
Enable gateway
Move the switch to the right to allow devices of the mesh network to
use this device for connecting to the Internet.
It is recommended to move the switch to the right when configuring
the main device.
It is recommended to move the switch to the left when configuring a
subordinate device.
Page 180 of 303
To Next Page
Loading...
