DIR-882 AC2600 Wave 2 MU-MIMO Wi-Fi Gigabit Router with
3G/LTE Support and 2 USB Ports
User Manual
Configuring via Web-based Interface
If the SNMP manager operates over SNMPv3, create a read-only user which will be used by the
SNMP manager to get data on the device. To do this, in the Users section, click
the ADD button ( ).
Figure 169. The window for adding a user.
In the opened window, specify the needed parameters:
Parameter Description
Name Specify a username for access from the SNMP manager.
Authentication protocol
Select a required authentication method from the drop-down list or
leave the None value if authentication is not required.
Authentication
password
Specify a password for user authentication from the SNMP manager.
The field is displayed if the MD5 or SHA value is selected from the
Authentication protocol drop-down list.
Encryption protocol
Select a required encryption method from the drop-down list or
leave the None value if encryption is not required. The list is
displayed if the MD5 or SHA value is selected from the
Authentication protocol drop-down list.
Encryption key
Specify an encryption key for data exchange between the SNMP
agent and SNMP manager. The field is displayed if the DES or AES
value is selected from the Encryption protocol drop-down list.
MIB subtree
Specify a MIB element which will be available to the SNMP
manager.
Click the SAVE button.
Page 216 of 303
To Next Page
Loading...
