Address Learning: Enable or disable the address learning function. The default setting is Enabled.
System > Port Configuration > Port Description
In the Port Description page, you may name various ports on the Switch.
Figure 4.17 – System > Port Configuration > Port Description
From Port / To Port: Specify the range of ports to describe.
Medium Type: Specify the media type of the port
Description: Specify the description of ports.
Click Apply to set the description in the table.
System > Port Configuration > Port Error Disabled
The Port Error Disabled page displays the information about ports that have had their connection status
disabled, for reasons such as link down status.
Figure 5.21 – System > Port Configuration > Port Error Disabled
Port: Displays the port that has been error disabled.
Port State: Describes the current running state of the port, whether Enabled or Disabled.
Connection Status: This field will read the uplink status of the individual ports, whether Enabled or Disabled.
Reason: Describes the reason why the port has been error-disabled.
System > IPv6 Settings > IPv6 System Settings
From this page you can configure IPv6 system information.
.
To Next Page
Loading...
